| Model | Cisco Aironet 1830 Series Access Points |
| Software | Cisco Unified Wireless Network Software Release with AireOS wireless controllers: |
| ● 8.1.121.0 or later for the Cisco Aironet 1830 Series Access Points | |
| Memory | 1GB RAM |
| 56MB Flash | |
| Data Transfer Rate | 1 Gbps |
| Integrated antenna | ● 2.4 GHz, gain 3 dBi, internal omni, horizontal beamwidth 360° |
| ● 5 GHz, gain 5 dBi, internal omni, horizontal beamwidth 360° | |
| Interfaces | ● 1 x 10/100/1000BASE-T autosensing (RJ-45), Power over Ethernet (PoE) |
| ● Management console port (RJ-45) | |
| ● USB 2.0 (enabled via future software) | |
| Indicators | ● Status LED indicates boot loader status, association status, operating status, boot loader warnings, boot loader errors |
| Input power | ● AP1830: 44 to 57 VDC |
| Requirements | ● Power supply and power injector: 100 to 240 VAC; 50 to 60 Hz |
| Power draw | ● 15.4W |
| Note: When deployed using a PoE specification, the power drawn from the power sourcing equipment will be higher | |
| by some amount, depending on the length of the interconnecting cable. | |
| Powering options | ● 802.3af/802.3at |
| ● Enhanced PoE | |
| ● Cisco local power supply, AIR-PWR-C= | |
| ● Cisco power injector, AIR-PWRINJ5= (Note: This injector supports 802.3af only), AIR-PWRINJ6= | |
| Note: If 802.3af PoE is the source of power, the USB port is disabled. | |
| Dimensions(W x L x H) | Access point (without mounting bracket): 8.3 x 8.3 x 2 in. (210.8 x 210.8 x 50.8 mm) |
